News | MJM Electric

News

2019 Safety Banquet

MJM Electric is set to hold their “Safety Banquet” on August 24th 2019. This banquet, held almost annually, is an employee favored event. This is a night to recognize the hard work and dedication required on a daily basis to maintain our safety first culture. This event is used to promote fellowship amongst the field […]

› Read More

Associated Asphalt – Mixer #5

MJM Electric recently began work on the installation of power & instrumentation cables for LDT 5 Tank at the Port of Tampa facility. We were tasked with the installation of 6” Aluminum cable tray, #2 and #18 shielded tray cable to the top of LDT #5 tank.

› Read More

Hostway – Server Room Power

MJM Electric is happy to add Hostway Services, Inc to our family of customers. We are installing three new 225 amp panels with #4/0 feeders and twelve cabinets at their Tampa facility. Once connected, the thirty-two added branch circuits will allow confidence in redundancy that is demanded in a server environment.

› Read More

Tampa International Airport – New CT Scanners

MJM Electric was recently tasked with providing power and data connections for Tampa International Airport new CT Scanners. These CT scanners are being installed for the use by TSA for the safety of the travelling public. MJM Electric has been asked to install the infrastructure for the five additional lanes that are to be added as part of this project.

› Read More

MJM Electric Completes Traction Rail Installation

MJM Electric recently completed concurrent projects at Tampa International Airport and Orlando International Airport playing a major role in the construction and commissioning of the new Mitsubishi Automated People Movers. As part of the construction teams, MJM Electric provided project management assistance, field supervision, logistic support, manpower & field engineering.

› Read More

University of South Florida (USF) – Ongoing Maintenance Work

MJM Electric was tasked with the emergency replacement of a 15 kV circuit. MJM Electric, Inc. was responsible with locating and procuring multiple load break and submersible butt splice kits. We demolished/removed and replaced approximately 300 feet of 15 kV #4/0 copper tape cable and did all of the required terminations during one 10 hour shift to meet the scheduling requirements of the customer.

› Read More

Mosaic- SAP Boot Pump

MJM Electric is installing owner furnished 480 volt switchgear and a VFD cabinet for Mosaic at the New Wales Facility. This installation required the pouring of a new housekeeping pad to set the switchgear and VFD cabinet. MJM Electric is also installing new cable tray and brackets to refeed a new boot pump that will replace existing 2300 volt pump. We are installing parallel 3/C – #4/0 AIA cable to the location of new pump as well as a new pushbutton station and control wiring from new VFD cabinet to DCS cabinet.

› Read More

Saputo Filler Room Project

MJM Electric is currently working on a Filler room project at Saputo. This project is currently being conducted with 2 different vendors for installation. The first part of this project required the demo of the existing electrical components to the old conveyor system.

› Read More

Mark Mazur retires as NECA PLC National Chairman

Mark Mazur retires as NECA PLC National Chairman, leading NECA PAC to the most successful election cycle in NECA history. Eric Hott was appointed the NECA PLC representative for the Florida West Coast NECA Chapter.

› Read More